Automatic Drinking Water Pump Wholesaler introduces what should be paid attention to when repairing water dispensers?

1. The frequent failure of the water dispenser is the problem of water leakage or no water, which can solve the problem of water leakage. As long as the water inlet of each filter element is disassembled one by one, you can find out which level of filter element is blocked, and find Then unscrew the connector of the filter element, shake it or wash it with tap water for a while, and then reinstall it if there is no foreign matter.

2. When there is a problem that the water dispenser cannot be heated or cannot be cooled, you can first check whether the switch behind the water dispenser is turned on. If it is turned on and still cannot be heated, open the rear panel of the water dispenser and check whether the wires are present. The phenomenon of loosening, if there is a loose situation, only need to reconnect the wires.

3. When the temperature is inaccurate, you can replace the thermostat. First, open the back cover of the water dispenser. After removing the screws, you can replace the thermostat. During the installation of the thermostat, you must pay attention to whether the thermostat is Close to the gall wall of the hot water, tighten the screws after installation is complete.

4. When the water tank of the water dispenser overflows, the float needs to be replaced. First remove the top cover of the water dispenser, then remove the water tank, open the cover of the water tank to replace the float.

Through the above introduction, Smart Drinking Water Pump Suppliers hopes that you can simply refer to the content of this article in future use.