As a professional street light manufacturer, I will explain how to install Solar led street light(CLASSICLEDLIGHT) today. I believe readers can learn the installation process in the fastest way. Some steps are applicable to the replacement of solar LED street light.

Installation steps:

Step 1: Install the solar LED street light pole. Use the high-altitude elevator to bundle the poles and then *** the vertical. Take care of the cables. Connect the LED street light poles to the base of the streetlights by bolt fastening to adjust the verticality.

Step 2: After completing the installation of the light post, install the LED street light line part, such as the solar panel, the battery, and the light source wire are connected to the controller.

Step 3: First connect the wires of the light source directly to the wires of the battery to see if the light source is on. You can determine the positive and negative poles of the wires of the light source. (The light source is not bright after the positive and negative poles of the light source are connected, and the light source will not be damaged. Feel free to test the light), then connect the positive wire of the light source to the red line corresponding to the bulb icon on the controller, connect the negative pole of the light source to the black line corresponding to the bulb icon on the controller, and install the controller wiring.

Step 4: Check the positive and negative poles of the battery outlet with the DC voltage file of the multimeter, connect the positive pole of the battery to the red line corresponding to the battery diagram on the controller, and connect the negative pole of the battery to the controller.

Step 5: Check the positive and negative poles of the solar panel outlet with the DC voltage file of the multimeter, connect the positive electric wire under the radiator of the solar panel to the red line corresponding to the solar panel on the controller and connect the negative wire of the solar panel. To the controller, there is a black line corresponding to the solar panel.

Step 6: The street light controller does not need to be debugged again. After the line is connected, it will enter the working state directly, because the program has been debugged at the factory and the time for setting the intelligent lighting is set.

Precautions:

The battery box of the solar LED street light should be installed in a sealed state. The threaded waterproof pipe should be 20CM above the ground to prevent rainwater from penetrating into the battery box. The position of the solar panel should be chosen reasonably. It is necessary to ensure that the sun is exposed for as long as possible to reach a long-term charging state.

Click Led street lights Manufacturers to learn about more information.